Menu

How to Paste Background in the corners: instructions, gluing outer, inner corner, docking

Step by step directions for gluing inner corners

When completing, the major problem can be uneven walls and the resulting folds on the background. It is also vital to take into account that when the walls are crooked, the joints of wallpaper canvases could invisibly.

After gluing the last one in front of the inner corner of the cloth should measure the remaining distance. It’s measured from the edge of the pasted cloth to the adjacent wall, the resulting amount is inserted 10-15 millimeters. If the walls are extremely curved, then the additional figure may be .

Cut a strip equivalent to the resultant figure, taking into account the allowance. The surfaces are treated with glue. Depending on the form of coating it can be just the wall or both surfaces.

The strip is then glued independently using the cut side into the wallsocket. The wallpaper should go on the opposite airplane.

If the glued wallpaper is sterile, then you want to make several small cuts perpendicular to the folds.

Level or incline on the adjacent wall is a vertical lineup. The distance from the corner is equivalent to the width of the last cut strip, not adding additions.

The surfaces have been smeared with adhesive, and the coating is glued to the wall with the flat side into the line. The cut goes onto the adjacent wall.

Protruding corner ought to be glued by analogy using the interior, but there are small gaps, which also have to be taken into consideration when working.

Measured the distance remaining out of the glued background into the adjacent wall. Add 20-25 millimeters to the captured figure.

A section is cut off, taking into account the additional 20-25 millimeters.

Before gluing, the surfaces have been treated with glue.

The edge must be glued to the wallpaper fixed onto the walls, the own cut facet”goes” to the adjacent plane. If needed, small cuts are made in the place of visiting the other wallpaper, smoothed and pressed to the wallsocket.

Draw a vertical gidpola.ru strip onto the adjacent wall at a distance of only glued cut strip and 6-10 millimeters.

After applying the adhesive, the strip is put on the wall using its flat side into the line, moving over the edge of this already glued strip.

The joints have been smeared with glue and ironed using a roller. Following that, the top layer is cut along the ruler and the two layers are combined together.